Remote control + receiver 2 automation channels type 2

Voltage working : DC12V
Operation 30mA
Frequency operating: 315 / span> 433MHz
Distance Transmission: 200m

Configured without self-maintenance

Configuration is done as follows:< /p>

1) Without self-maintenance - keep pressing the mode button until the LED it turns on and then flashes once and goes off for approx. (9-10 seconds), after which it is pressed again for 2-3 seconds until the LED stays on and a button on the remote control is pressed. p>

2) With self-maintenance - keep the mode button pressed until the LED it turns on and then flashes twice and goes off (13-14 seconds), after which it is pressed again for 2-3 seconds until the LED stays on and a button on the remote control is pressed. p>

3) With keyboard type self-maintenance (when one relay is activated the others are off) - press and hold the mode button until the LED lights up and then it flashes three times and goes out (17-18 seconds), then press it again for 2-3 seconds until the LED stays lit and a button on the remote control.