Remote control + receiver 2 automation channels type 1

Receiver power supply: 12V
Max. power: 3A
To match the remote control with the receiver, press and hold the button on the receiver for 3 seconds, until the receiver LED stays on. Thus, the receiver enters the learning mode of the remote control. Press the buttons on the remote control, waiting after each press for the LED to flash 3 times, a sign that the button has been learned
It is used for remote operation of various devices (e.g.: lighting systems, gates, etc. ) via the radio remote control.
Operating mode: Each time you press the remote control button corresponding to the channel, the status is switched.

Configuration is done as follows:< /p>

1) Without self-maintenance - keep pressing the mode button until the LED it turns on and then flashes once and goes off for approx. (9-10 seconds), after which it is pressed again for 2-3 seconds until the LED stays on and a button on the remote control is pressed. p>

2) With self-maintenance - keep the mode button pressed until the LED it turns on and then flashes twice and goes off (13-14 seconds), after which it is pressed again for 2-3 seconds until the LED stays on and a button on the remote control is pressed. p>

3) With keyboard type self-maintenance (when one relay is activated the others are off) - press and hold the mode button until the LED lights up and then it flashes three times and goes off (17-18 seconds), then press it again for 2-3 seconds until the LED stays lit and a button on the remote control.